Custom Series · Foldable
A foldable case is not a slab case with a bend in it. The hinge adds a moving part, a gap that collects grit, and a surface no rigid material can cover. Every range below is built around that constraint first and styled second.
Click through for full specifications, colourways and model coverage.
Almost every foldable case complaint traces back to one of four things. All four are engineering problems, not material quality problems.
| Failure | Cause | What we do |
|---|---|---|
| Hinge cover peels at the edges | Flex section bonded to a rigid half with poor adhesion | Bonded flex between two rigid halves, 200-cycle tested before a run |
| Phone will not close flush | Case 0.2 mm too thick on one face | Closing-face tolerance held on every mould; all hardware kept off that face |
| Leather cracks at the fold | Leather used as the load-bearing layer across the hinge | Leather on the two rigid faces only; a flex material crosses the fold |
| Magnets feel weak | Array placed over the hinge, or panel too thick above it | Array routed into the lower back panel, panel held to 1.2 mm over the zone |
The hinge cover cannot seal the gap — no case can, because the phone must still fold. What it does is shelter the gap so pocket lint, sand and crumbs cannot drop straight into the mechanism.
| Buyer | Range | Reason |
|---|---|---|
| Wants MagSafe accessories on a foldable | Magnetic foldable, ice-feel magnetic, gold clear magnetic | N52 array clear of the hinge, up to 15 W |
| Wants a stand that survives an open phone | Rotating foldable, gold gloss rotating, 3D stand | Lockable detents spread load; a free-spinning ring collapses under an open foldable |
| Carries an S Pen daily | Card & pen slot, gold armor pen slot, gold eye pen slot | Channel along the spine, clear of the flex |
| Wants premium surface for photography | Leather card, AG matte, gold silk, gold shine | Finishes that read as premium and take debossing or plating |
| Privacy on the cover display | HD clear privacy, privacy magnetic | 28° tempered privacy layer, ≈68% head-on transmission |
| Slimmest possible | Diamond minimal | No hardware on the back panel, cleanest flush closing |
No, but without it the hinge gap collects debris, and debris is the main cause of hinge wear. For a phone that lives in a pocket or bag, coverage is worth the cost.
Not with leather alone — it does not elongate and will crack. Ask any supplier which material crosses the fold.
More parts, tighter tolerances, a flexible hinge section and more assembly steps. Tooling is more complex and takes longer.
Yes. Fold 1–3 moulds are still in service on the diamond ring stand and diamond minimal ranges.
Send the exact models and quantity. We confirm mould availability the same day.
